74ACT16823DLR.A中文資料德州儀器數據手冊PDF規格書

EPICE (Enhanced-Performance Implanted

CMOS) 1-mm Process

Members of the Texas Instruments

WidebusE Family

Inputs Are TTL-Voltage Compatible

Provide Extra Data Width Necessary for

Wider Address/Data Paths or Buses With

Parity

Flow-Through Architecture Optimizes PCB

Layout

Distributed VCC and GND-Pin Configuration

Minimizes High-Speed Switching Noise

Package Options Include Plastic Shrink

Small-Outline (DL) Packages Using 25-mil

Center-to-Center Pin Spacings and 380-mil

Fine-Pitch Ceramic Flat (WD) Packages

Using 25-mil Center-to-Center Pin Spacings

description

These 18-bit flip-flops feature 3-state outputs

designed specifically for driving highly-capacitive

or relatively low-impedance loads. They are

particularly suitable for implementing wider buffer

registers, I/O ports, parity bus interfacing, and

working registers.

The ’ACT16823 devices can be used as two 9-bit

flip-flops or one 18-bit flip-flop. With the

clock-enable (CLKEN) input low, the D-type

flip-flops enter data on the low-to-high transitions

of the clock. Taking CLKEN high disables the

clock buffer, thus latching the outputs. Taking the

clear (CLR) input low causes the Q outputs to go

low independently of the clock.

A buffered output-enable (OE) input can be used to place the outputs in either a normal logic state (high or low

logic levels) or the high-impedance state. In the high-impedance state, the outputs neither load nor drive the

bus lines significantly.

OE does not affect the internal operation of the flip-flops. Old data can be retained or new data can be entered

while the outputs are in the high-impedance state.

The 54ACT16823 is characterized for operation over the full military temperature range of –55°C to 125°C. The

74ACT16823 is characterized for operation from –40°C to 85°C