TPSM83100中文資料德州儀器數(shù)據(jù)手冊(cè)PDF規(guī)格書

1 Features

? 1.6-V to 5.5-V input voltage range

– Device input voltage > 1.65 V for start-up

? 1.2-V to 5.5-V output voltage range

– 1.0-V Vout is supported in PFM mode

? High output current capability, 3-A peak switch

current

– 1.5-A Iout for VIN ≥ 3 V, VOUT = 3.3 V

– 1.2-A Iout for VIN ≥ 2.7 V, VOUT = 3.3 V

? Active output discharge (TPSM83101 only)

? High efficiency over the entire load range

– 8-μA typical quiescent current

– Automatic power save mode and forced PWM

mode

? Peak current buck-boost mode architecture

– Seamless mode transition

– Forward and reverse current operation

– Start-up into pre-biased outputs

– Fixed-frequency operation with 2-MHz

switching

? Safety and robust operation features

– Overcurrent protection and short-circuit

protection

– Integrated soft start with active ramp adoption

– Overtemperature protection and overvoltage

protection

– True shutdown function with load disconnection

– Forward and backward current limit

? Small solution size

– MicroSiP? power module with integrated

inductor

– 2.0-mm × 2.6-mm × 1.2-mm(max) 8-pin μSiP

package

2 Applications

? Voltage stabilizer (datacom, optical modules,

cooling/heating)

? System pre-regulator (smartphone, tablet,

terminal, telematics)

? Point-of-load regulation (wired sensor, port/cable

adapter, and dongle)

? Fingerprint, camera sensors (electronic smart lock,

IP network camera)

3 Description

The TPSM83100 and TPSM83101 are constant

frequency peak current mode control buck-boost

MicroSiP? power modules optimized for small

solution size and high efficiency. The power modules

integrate an inductor to simplify design, reduce

external components and save PCB area. They

have a 3-A peak current limit (typical) and 1.6-V

to 5.5-V input voltage range. The TPSM83100 and

TPSM83101 provide a power supply solution for

system pre-regulators and voltage stabilizers.

Depending on the input voltage, the TPSM83100 and

TPSM83101 automatically operate in boost, buck, or

in 3-cycle buck-boost mode when the input voltage

is approximately equal to the output voltage. The

transitions between modes happen at a defined

duty cycle and avoid unwanted toggling within the

modes to reduce output voltage ripple. 8-μA quiescent

current and power save mode enable the highest

efficiency for light to no-load conditions.